EG-2-DIN-RAIL-CARRIERS EG-2 DIN Rail Carriers Mounting instructions.
The EG-2-DIN-RAIL-CARRIERS is the accessory kit for mounting the that will be used to mount the new EG-2 controller to a standard DIN Rail.
The hardware in the EG-2-DIN-RAIL-CARRIERS kit includes two carriers and four screws, two #4 5/16 round head screws for each carriercareer.
Assembling the carriers to the back of EG-2
Two carriers will be installed in each EG-2, one on each side of the EG-2.
The carriers will be screwed to the screw provision provided on the back case of the EG-2. Caution: Do not overtighten screws into the EG-2 housing, do not use any screws other than the ones provided.
...
Assembling the EG-2 with the carrier to the DIN rail
The carriers assembled to the back of EG-2 should be clipped to the DIN rail (provided by others).
...
Note: The locking latch can engage in four positions. To easily change the position of the latch, press the base lightly while activating/deactivating the latch. The latch lock should be released by pressure, thus avoiding any possible damage to the notch in the guide slide.
...