EG-2 DIN RAIL CARRIERS Instructions

Owned by Vinodhraj DP
Last updated: May 22, 2024 by Steven Lewis
2 min read

EG2-DIN-KIT EG-2 DIN Rail Carriers Mounting instructions.

The EG2-DIN-KIT is the accessory kit that will be used to mount the EG-2 controller to a standard DIN Rail.

The hardware in the EG2-DIN-KIT includes two carriers and four screws, two screws for each carrier.

Assembling the carriers to the back of EG-2

Two carriers will be installed in each EG-2, one on each side of the EG-2.
The carriers will be screwed to the screw provision provided on the back case of the EG-2. Care should be taken when assembling to not over tighten the included screws.

image-20240430-120123.png

Assembling the EG-2 with the carrier to the DIN rail

The carriers assembled to the back of EG-2 should be clipped to the DIN rail (provided by others).

image-20240517-024629.png

Note: The locking latch can engage in four positions. To easily change the position of the latch, press the base lightly while activating/deactivating the latch. The latch lock should be released by pressure, thus avoiding any possible damage to the notch in the guide slide.

 

 

 

Â