Page Comparison

...

1. Login to Primis with the Admin User account.

2. Click on the System navigation tab.

3. On the left, click on the ASSA ABLOY link.
   

   Image RemovedImage Added

4. Enter the name of the DSR server. This can be any arbitrary name and does not have to reflect the DSR servers hostname.

5. Enter DSR IP - this is the IP Address of DSR server. Default port is 8080.

6. Enter Callback IP – this is the IP Address used by the DSR server to report event logs back to Primis. The IP Address should be the Primis server’s own IP and default port number is 9001.

7. User Limit – this controls the maximum number of cardholder information that can be stored in the ASSA ABLOY Wi-Fi and PoE locks. This value should reflect the User Limit set on the DSRunder DSR Tools Configuration Settings -> Device Specific Commands -> Default Settings -> Lock Limits. The User Limit specified in Primis should be less than or equal to DSR’s default user limit.

8. Click Save to update DSR Settings. In a few minutes, the Status tab below will display various interface statuses. Should the DSR Interface status remains Offline after a few minutes, reboot the Primis server.
   

   

9. Configure Access Points (Wi-Fi and PoE Locks) to connect to DSR using Assa Abloy’s Lock Configuration Tool (LCT). Once Access Points are configured, they should appear in Primis under the Access Points tab.
   

   

10. To integrate a Wireless Access Point into Primis, there are 4 simple steps:

    1. Confirm – to let DSR confirm that the Access Point will be in use.

    2. Import – to map the Access Point into a Primis wireless lock device.

    3. Assign Controlled Area – Create a Wireless Lock Controlled Area and assign it with the Access Point.

    4. Assign Access – assign the Wireless Lock Area to Access Group as if it were a regular Door Area.

11. To Confirm an Access Point with DSR, click the corresponding green Confirm Device button.
    

    

    Access Point’s Confirm status will change to  

    

    in the next few minutes. This process could take some time; depending on the wake-up interval of the Access Point.
    

    

12. Once the device is confirmed, click the blue Import Device button to map the access point to a Primis Assa Abloy Wireless Lock Device:
    

    

    Primis will proceed to an Add Custom Device page, and the name of the Access Point and the Door ID will be populated automatically. Click Save and then Cancel.
    

    

13. Click Controlled Areas tab, and click Add Controlled Area.

14. In Area Type, make sure Wifi Lock Area is selected. Then select the mapped Wifi Device under Wifi Lock:
    

    

15. Click Save.

16. Assign the Wifi Lock Area to User Access Group. The Wifi Lock is now ready to be used.
    

    

...